About cfe223 vs h335
About cfe223 vs h335
Blog Article
Hogdon nonetheless lists it as slower the 748 on there burn off chart but their on the net data shows it considerably quicker. I also examine someplace it had been dirty....I need to "study" prior to I buy I suppose!
It's not at all important, nor fascinating, to make use of magnum smaller rifle primers with 223 and H335. Clark
Will not rule out H335 for the Big Bores possibly. Examine Hornady and Barnes for that .458 Gain Mag and .45-70 Using the heavies. I have located almost nothing improved in These two. And I'm not by itself in that discovery -- once you will need more area for powder.
I named them not too long ago asking why so several powders ended up shown for his or her bullets and was educated that they are continuously working on new loads but just Really don't appear to obtain the updates on their Web site as brief as they must.
That is an older thread, you may not receive a response, and will be reviving an old thread. Make sure you think about making a new thread.
Should really I give absent the ability to some buddy That may get some decent use outside of it, or keep onto it in case I get Yet another gun that might do perfectly with it?
Just purchased an 8 lb. jug of H335 a couple months again. Not a foul deal and it really works very well ample for me.
With some powders that do not meter as regularly as All those two ball powders I use the modest light-weight to check for (one) is there powder in the situation and (2) do any seem lighter or heavier than the rest? If that is so (lighter/heavier) I pull those with the tray and weigh them.
Originally I thought it would only be fantastic for 223-sized cartridges. As I uncovered more about this powder, I was amazed With all the wide selection of cartridges it is well suited for, from the small 204 Ruger up into the 375 H&H!
That’s not to say it’s just as easy to things a seventy seven-grain bullet in the heaviest situation you’re reloading atop an entire cost of BL-C(2) as it is Using the lightest piece of brass within the batch. Just that, in most apps, you gained’t find an important change than if you just segregate your cases by headstamp.
I reload in batches. Resize a bunch of brass. Trim case mouths on a bunch of brass. Key lots of brass. When I get adequate to make it worth it I grab the powder and also the bullets (55 grain Hornady FMJ) and begin setting up the powder evaluate and scale and press.
The team on the right would be the balistic tips, I belive This is certainly thirty pictures but dont quote me, this was very last Winter season. 100yds also.
1gr off, I'm not about to sweat it on a bulk load. Especially for ball powder. May ensure the 1st 3 soon after currently being pleased with exactly where 10 toss. Then carry out some randoms to be certain it hasn't walked. Generally wander within the demand around with my small-conclusion Escale, then confirm using a beam kind for velocity.
Then both equally of them tried several of the plastic ideas, and changed their minds. When I attempted Benchmark and Ramshot TAC from the .223 my website remaining H335 went unused. And currently you can find more thoroughly clean-burning acceptable powders.